3-10
Chapter3 Setup
10
Press the key.
11
Press the key several times to
end the setting.
Setting of Interval Wiping
When the set time has passed, nozzle face of the head is
cleaned automatically to remove ink droplets on the
nozzle face.
In case that deflection, nozzle missing, or symptom which
ink droplets fall down occurred, set the interval between
each operation shorter.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select "Setting" and
press the key.
3
Press to select SETUP 1 to 4, and
press the key.
• The setup menu appears.
4
Press
(<<)
.
5
Press to select "INTERVAL
WIPING", and press the key.
6
Press to set intervals.
• Set Value: 3 to 255 minutes, OFF
• When [OFF] is set, periodical wiping is not
executed.
7
Press the key.
8
Press the key several times to
end the setting.
Setting of the UV Mode
You can select the mode for the LED UV device from 3
types.
By setting the UV mode, you can turn off LED UV light
when, for example, you are using media that is sensitive
to heat or you are going to perform test cutting while
cleaning.
1
In LOCAL mode, press the
(MENU)
key.
2
Press to select "Setting" and
press the key.
3
Press to select SETUP 1 to 4,
and then press the key.
• The setup menu appears.
4
Press to select "UV Mode", and
then press the key.
5
Press to select a mode, and then
press the key.
• Available settings: ON/OFF/No printing
6
When you are finished setting the UV
mode, press the key several
times.
Setting Ionizer (option)
Connect the ionizer and set it on when removing static
electricity.
1
Press the
(MENU)
key in local.
2
Press to select "Setting" and
press the key.
• The setting menu is displayed.
3
Press to select "Ionizer" and
press the key.
4
Press to select the setting
value, then press the key.
• Setting value: ON / OFF
• Depending on the state of the heads, etc., the
image quality deterioration may not be improved
even with this function performed. In this case,
contact our service office or the distributor in your
region.
ON Turns on LED UV light.
OFF Turns off LED UV light while printing.
No
printing
Turns on LED UV light without performing printing.
This mode is useful when, for example, you did
not turn on LED UV light during printing but later
on decide to cure the ink. (This mode is usually
not set.)
• For safety, please refer to "UCJV Series Ionizer
Operation Manual".
• Displayed when the ionizer is connected.
To Next Page
Loading...
