Chapter 4 Cutting Function
4-15
4
2
2
Make the media without uncut area (OVER CUT function)
By over lapping the start point and the end point arbitrarily, you can make
the media without uncut area.
Specify the OVER CUT function (valid/invalid) and the length of the
OVER CUT. If the length of the OVER CUT is set, when cut starts, cut will
be performed from the position to the front by the specified length and the
tool will move up going too far at the end.
Additionally, you can enable the corner cut function to perform overcutting
of corners other than the start and end points.
1
Press the
(MENU) (>>)
key in LOCAL.
• The cutting MENU will be displayed.
2
Press to select the "SETUP SUB
MENU", and press the key.
3
Press to select "OVER CUT", and
press the key.
4
Press to select the setting item
and press the key.
• Set value: OFF/ 0.1 to 1.0 m (in 0.1 mm
increment)
• When you press the [ENTER] key, the setting for
“CORNER CUT” setting will be displayed.
5
Press to select ON/OFF, and
press the key.
6
Press the key several times to
end the setting.
Other SETUP SUB MENU
How to set other convenient functions is explained below. Change the settings according to the types of use.
1
Press the
(MENU) (>>)
key in LOCAL.
• The cutting MENU will be displayed.
2
Press to select the "SETUP SUB
MENU", and press the key.
3
Press several times, and select an
item to set.
• See "List of Settings" to select one.
4
and press the key.
5
Press to select a set value.
• See "List of Settings" to select one.
6
and press the key.
7
Press the key several times to
end the setting.
List of Settings
The setting is as follows when purchasing:
• Setting proper OVER CUT
can reduce uncut area of
start and end point of a
media easy to bend. If too
large value is set, the result
may have a rupture.
OVER CUT : OFF
OVER CUT : 1.0mm
OVER CUT
part
Corner cut
part
• The setting values are kept in memory even when
the power is turned off.
Function name Description Setting Value
*1
Setting the UP SPEED
This is to set the speed of sheet and carriage movement when the tool is up.
Setting the speed lower makes the sheet misalignment reduced at the
time of long sheet feeding.
5,10,20,30, AUTO (cm/s)
Setting the DUMMY CUT ( P.4-16) The operation of dummy cutting is set. OFF / ON
SHEET TYPE
*2
This is to set the types of sheet according to the sheet you use. Standard / Heavy
Setting the ADJ-PRS OFFSET
(P.4-16)
This is used to expand the value in such a case as when the
beginning and end part of the cut are left cut.
0 ~ 3
~ 7
Curve mode
If the cut line bends, set it to "SLOW".
Although the cutting speed decreases, it is possible to prevent a bent.
SLOW / FAST
*1. The underlined values are set at purchase.
*2. If you set “Heavy” for the media setting, the cutting speed will be limited to 20 cm/s.
To Next Page
Loading...
