MIMAKI UCJV300-75 - About NOZZLE CHECK MENU; INFORMATION MENU Table

Chapter 3 NOZZLE CHECK
3-23
1
2
3
4
5
6
About NOZZLE CHECK MENU
Set operations concerning the nozzle missing detection function.
INFORMATION MENU table
Function name Set value Default Description
Printing Check
(P.3-25)
ON/OFF OFF
Set this when you want to conduct nozzle check at the
beginning of online printing.
(ON)
Check
Interval
LENGTH 0.1 to 50.0 m 30.0m Conducts nozzle check at each set length.
FILE 1 to 100 30 files Conducts nozzle check at each set number of files.
*1
*1. When the set length is reached during printing, nozzle check is conducted at the start of the next printing.
Action
CLEANING
OFF/ SOFT/
NORMAL/ HARD
SOFT Sets the type of cleaning performed during recovery work.
RETRY
COUNT
0 to 3 0 Repeats the retry operation for the set number of times.
NOZZLE RECOVERY ( P.3-
25)
ON/OFF OFF Set this when you want to conduct automatic nozzle recovery.
Judgment Condition ( P.3-25) 1 to 64 1
Sets how many missing nozzles are detected for "Nozzle
Missing" judgment to be made according to each color.
(Maximum 16 per 1 nozzle line)
*2
*2. Depending on the print conditions, nozzle recovery is not applied in some cases.
three
times
width:1340mm
REMOTEMENU
TEST PRINT
CLEANING
LOCAL
NOZZLECHECK
PrintingCheck
OFF
OFF
NOZZLERECOVERY
>
JudgementCondition
MENU
SETUP
>
> MAINTENANCE
>
MACHINESETTUP
NOZZLECHECK
>
>
INFORMATION
>><<
width:1340mm
REMOTEMENU
TEST PRINT
CLEANING
LOCAL
Press this to confirm a
setting, etc.
 NCU MENUs at-a-glance
Press this to select
INFORMATION MENU, or to
switch to the previous screen.
Press this to switch to the
next screen.
Use these to select a
setting item.