MIMAKI UCJV300-75 - Setting the Pinch Roller Pressure

2-13
2
2
2
2
2
Chapter 2 Basic Operation
15
Fix the media to the take-up device.
(1) By pressing [], feed the media until it
reaches the core of the take-up device.
(2) Fix the middle of the media with adhesive
tape.
(3) In the same manner, fix the left side and right
side of the media.
• Make sure that the there is no slack or
wrinkle on the media in such condition that
the roll media is pulled to right and left evenly,
and stick the tape.
(4) Press the [ENTER] key
Setting the Pinch Roller Pressure
After setting the media in place, set the pressure to be
applied to the pinch rollers that retain the media.
Setting an inappropriate pressure for the pinch rollers can
cause not only the media to become skewed during
printing or cutting but also the pinch rollers to leave traces
on the media.
The set pressure must be appropriate to the media set on
the machine.
You can set the following items in pinch roller pressure
settings:
1
Press twice in LOCAL, and then
press the (PR) key
2
Press to select a setting item,
and then press the key.
3
Press to select a setting.
4
Press .
5
Press to finish.
Entering the media remaining amount
When [MEDIA REMAIN] of the machine setting is set
to “ON”
( P.3-15), the screen for entering the media
length is displayed after detecting the media width.
1
The input media length screen is
displayed.
2
Press to enter the media
remaining amount.
3
Press the key.
Setting the manual media width
When [MEDIA DETECT] of the machine setup is
"MANUAL" ( P.3-15), set the media width with the
following method.
1
The right edge position screen is
displayed.
2
Press to enter the right edge
position of the media.
3
Press the key.
• Next, the screen to enter the left edge position of
the media is displayed.
4
Press to enter the left edge
position of the media.
5
Press the key.
Item Setting Description
NUMBER
FOR USE
1 ～ 7
Set the number of the pinch
rollers you are using.
This number differs depending
on the model you are using.
PRINT
LOW/ MID/
HIGH
Set the pinch roller pressure for
printing.
CUT: ENDS
LOW/ MID/
HIGH
Set the pressure of the edge
pinch rollers (left and right
edges) used when cutting the
media.
CUT: INNER
OFF/ LOW/
MID/ HIGH
Set the pressure of the pinch
rollers except for the edge pinch
rollers used when cutting the
media.
CHANGE
EXECUTION
PRINT/ CUT
Switch between the setting for
printing and cutting.
50.0m
LENGTH
PRINT
INPUTMEDIALENGTH
＊＊＊．＊0．0
PRINT
RIGHTEDGEPOSITION
30°/35°
＊＊＊．＊0．0
PRINT
LEFTEDGEPOSITION