4-6
Chapter 4 Cutting Function
(4) OFFSET X / OFFSET Y
Generally the origin will be set at the position shown
below.
However, depending on your application and the work
to be cut, the cutting position may be misaligned in the
same direction. In this case, the location of the origin
can be corrected.
(5) DETECT END KEY START
(6) SENSOR LEVEL
(7) MARK FILL UP
ID Cut
It is a function that can cut automatically according to the
ID information simply by detecting the ID-contained data.
It is not necessary to output the cut data again after
printing the data.
For details, refer to "ID Cut Guide".
Print data
If you cut the media rotated by 90, 180, or 270 degrees,
set the media margins to the following values at rotated
conditions.
• Front end : 20 mm or more
• Left and right ends : 15 mm or more
• Rear end : 110 mm or more
210 mm or more (if a register mark copy
*1
has been made)
*1: The data whose register mark copy has been made more than one
by RasterLink.
1
Set the media.
2
Check if the print start position (the origin )
is set at 110 mm or more from the media
front end, and 15 mm or more from the
media right end.
• Make sure that the width of the media is equal to
or larger than [Entire image width (including the
register mark) + right 15 mm + left 15 mm].
• If any of the front / left / right margin is insufficient,
the media end may be mistaken as the register
mark, which may cause the register mark
detection to start earlier.
(1) Press the jog key in the local state. Move the
luminous point of the LED pointer so that the
print start position is 100 mm or more from
the media front end, and 15 mm or more
from the right end.
(2) Press the [ENTER] key.
• The print start position is changed.
3
Check if the print end position is set at 110
mm or 210 mm (if the mark copy has been
made) from the media rear end.
• Make sure that the length of the media is equal to
or larger than [Entire image length (including the
register mark) + 100 mm + 110 mm or 210 mm(if
the mark copy has been made)].
Setting Value Description
± 15.00 mm
Use this to shift the origin position in the X
direction or Y direction.
• If the origin is located out of the available cutting
area, “ERR37 MARK ORG” will be displayed. In
this case, write the register marks in the area
closer to the center of the media.
Setting Value Description
ON/OFF
If this is ON, you will be able to detect crop
marks with the [END] key.
• When set to ON, the cutter head moves when the
power is turned off.
Setting Value Description
1 to 7
The bigger the numerical value is, the higher
the sensitivity of the register mark sensor
becomes. If register marks are not detected,
increase the sensitivity. If register marks are
detected by mistake, lower the sensitivity.
Generally, use it with the setting value of “4”.
Setting Value Description
ON/OFF
Make the setting to “ON” when using the “Fill
around the register mark” function of the RIP
software to detect the printed register mark.
Use a register mark size of 10 mm or more
when filling in around the register mark.
Mark: Type 1 Mark: Type 2
Origin
Origin
Plus Y
direction
Plus X directionPlus X direction
Plus Y
direction
To Next Page
Loading...
