3-15
3
2
2
2
Chapter 3 Machine Setting
Setting of the Display of Media Resid-
ual
Whether the screen displays the remaining amount of a
media is set.
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press to select "MEDIA
REMAIN", and press the key.
3
Press to select a set value, and
press the key.
• Set Value: ON/OFF
4
Press the key.
5
Press the key several times to
end the setting.
Setting of Media Detection
Set the following two items in media detection settings.
1
Press
(MENU) (twice
)
.
• The MACHINE SETUP MENU appears.
2
Press to select "MEDIA
DETECT", and press the key.
3
Press to select AUTO/MANUAL.
4
Press the key.
5
Press to select "USE PR
NUMBER QUERY", and press the
key.
6
Press to select ON/OFF.
7
Press the key.
8
Press the key several times to
end the setting.
When the media
remaining amount
display is turned to
"ON"
The remaining amount of the media is
displayed during REMOTE mode.
(If you are using leaf media, the printed
length is displayed instead.)
When the media
remaining amount
display is turned to
"OFF"
The remaining amount of a media is not
displayed during REMOTE mode.
• The amount of a media that has been fed by the
printing and jog keys is reflected in the remaining
amount of a media.
• The length of the media (initial value of the remain-
ing amount) is entered when roll media is
detected. ( P.2-13)
• The setting configured here does not become
effective unless media detection is performed after
the setting has been complete.
Setting of Media
Detection
When loading the media, set whether
to detect the media width automatically
(AUTO) or decide the print (or cut)
range manually (MANUAL).
USE PR NUMBER
QUERY
Set whether or not to enter the number
of the pinch rollers you are using during
media detection.
• When using the media that cannot be detected by
the sensor, such as black cutting sheets, set the
media detection setting to "MANUAL".
When using the attached RIP software
(RasterLink)
• If you set the input of the number of pinch rollers
"OFF" in Step 8, the pinch roller pressure and the
number of use, that has been set in RasterLink,
may not match in some cases.
Set to "OFF" only when performing set of pinch
roller pressure ( P.2-13) in this machine.
To Next Page
Loading...
