Chapter 1 Before Use
1-10
If the computer or device connected to the printer uses a
network other than 1000BASE-T, printing is not possible.
After connecting the computer or device with the printer,
check the following:
(1) Check the information displayed on the screen on
the printer.
• From the local screen or media detection screen, press
the [Enter] key several times until the information screen
appears.
• Confirm that "1000Mbps" is displayed as the LAN status.
(2) Check the LAN connector's green lamp.
• After the main unit starts up, the LAN connector's lamp
can indicate one of the following states:
Connecting the Power Cable
1
Insert the power cable into the inlet on the
machine.
2
Secure a cable band.
• Secure the cable with the cable band attached to
this machine.
3
Insert the power plug into a plug socket.
• If [100Mbps], [10Mbps], or [Not connected] is dis-
played as the LAN status, you cannot print data
via a LAN.
• If [100Mbps] or [10Mbps] is displayed as the LAN
status, event messages will be available
( Chapter 3 Setting of Event Mail Function).
Color State State
Green
Solid
Connected via 1000BASE-T
Off
Connected via a network other
than 1000BASE-T
Yellow
Solid
Link-up
Blinking Data reception in progress
Off Link-down
• When only the yellow lamp is solidly lit or blinking,
the network is not running at 1000 Mbps. Check
the specifications of the computer, devices, and
cables.
Switching hub
Connecting the computer to the printers via a
switching hub
INFORMATION
LAN Status 1000Mbps
• Use only the power cable supplied with the
machine.
• Be sure to connect the power cable to the outlet
near this machine, and make sure that the power
cable can be easily removed.
• Connect the power cable to the grounded outlet.
Failure to observe this could lead to electric
shocks or fire.
Inlet
Power cable
Cable band
To Next Page
Loading...
