MIMAKI UCJV300-75 - Cleaning the Mist Filter

5-7
5
2
Chapter 5 Maintenance
8
Clean the wiper cleaner.
• Wipe off the ink sticking to the wiper cleaner with
a clean stick dipped in cleaning solution for
maintenance.
9
Set the wiper at the original position.
• Insert the wiper by holding the protrusions at its
both ends.
10
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance solution for
maintenance will not remain.
11
Press the key after the cleaning.
12
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
step 1.
Cleaning the mist filter
1
Press the
(MENU)
and
press the key.
• MAINTENANCE MENU will be displayed.
2
Press the key twice to select the
“CARRIAGE OUT”.
3
Press to select "HEAD
MAINTENANCE", and press the
key.
• The carriage will move to the left end of this
machine.
• A large amount of ink accumulates in the absorp-
tion case. Please absorb with water-absorbing
paper etc. about once a week.
• Do not remove the wiper cleaner from the bracket.
• Clean only the surface of the wiper on the wiper
cleaner. (It is not necessary to clean the rear side.)
• Do not remove the ink pad from the ink pad case.
• After cleaning the wiper cleaner, make sure that
the cleaner is not facing up.
Wiper cleaner
OK NG
Projection
• After cleaning the cap rubber, make sure that the
cap slider is not misaligned.
If the cap slider is misaligned, move the slider
block left and/or right to correct the alignment.
Cap rubber