Chapter 7 Appendix
7-3
1
2
2
2
2
2
7
Cutter Section Specifications
Item Specifications
Maximum speed
*1
*1. The maximum speed may be limited, depending on the size of a used medium. In addition, the cutting section does not operate with both speed and
acceleration being at the maximum.
30 cm/s (42 cm/s in the 45° direction) (118.1 in/s (165.4 in/s in the 45° direction))
Maximum acceleration 0.5G
Cutting pressure 10 to 450g (0.02 to 1.0lb)
Number of times the cutter responds
to a medium
10 times/sec
Usable tools
Eccentric cutter/ water-based ballpoint pen/ oil-based ballpoint pen/ Ballpoint pen for
handwriting (sold on the market)
*2
*2. Use one with a diameter of 8 to 9 Φ whose clamped part has no protrusion or taper. In addition, because the position of the pen point changes, depending on
the types of pens, no good image quality can be ensured.
Usable media
Polyvinyl chloride sheet (Thickness of 0.25mm or less with laminate) /fluorescent
sheet
*3
*4
reflecting sheet
*4
(excluding high-intensity reflecting sheets)/ Label card (paper-
based)/ Heat transfer rubber sheet (Polyvinyl chloride sheet (Thickness of 0.01in or
less with laminate)/ fluorescent sheet / reflecting sheet
*4
(excluding high-intensity
reflecting sheets)/ Label card (paper-based)/ Heat transfer rubber sheet)
*3. This conforms with our specified sheet. This conforms with our specified sheet.
*4. When a blade dedicated for fluorescent sheets (SPB-0007) or a blade dedicated for reflecting sheets (SPB-0006) is used. When a blade dedicated for
fluorescent sheets (SPB-0007) or a blade dedicated for reflecting sheets (SPB-0006) is used.
Margin
Leaf media
Left and right: 15mm (0.6in) (default value), Minimum: 5mm (0.2in), Front: 135 mm
(5.3in), Rear: 150 mm (5.9in)
Roll media
Left and right: 15mm (0.6in) (default value), Minimum: 5mm (0.2in), Front: 135 mm
(5.3in), Rear: 150 mm (5.9in)
Repetition accuracy
*5
*5. For repetition accuracy, see the lower part of this page.
± 0.2 mm or less (excluding expansion and contraction due to temperature)
Reception buffer memory 256 MB
Command MGL-II c2
Program step 25μm/step
To Next Page
Loading...
