MIMAKI UCJV300-75 - Setting of the CONFIRM. FEED; Setting of the SPACE FEED MODE; Setting of the Network

3-17
3
2
2
2
Chapter 3 Machine Setting
Setting of the CONFIRM. FEED
Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
In LOCAL mode, press
(MENU)
(twice
) .
• The MACHINE SETUP MENU appears.
2
Press
(>>)
once.
3
Press to select "CONFIRM.
FEED", and press the key.
4
Press to select a setting, and
press the key.
• Set Value: ON/ OFF
5
Press the key several times to
end the setting.
Setting of the SPACE FEED MODE
Change the feed mode of the margin included in the
image data (the space of no data to be printed). If print
data with much margin, set to “CONTINUOUS”, then the
print time can be shorten.
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press
(>>)
twice.
3
Press to select "SPACE FEED
MODE", and press the key.
4
Press to select a setting, Press
the key.
INTERMITTENT: Perform intermittent feed
operation of the path division
unit
CONTINUOUS: Feed the no data part at a time
5
Press the key several times to
end the setting.
Setting of the Network
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (https://mimaki.com/download).
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press
(>>)
twice.
3
Press to select "NETWORK", and
press the key.
4
Press to select "CHECK IP
ADDRESS", and press the key.
• The IP address currently used with this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
5
Press to select "CHECK MAC
ADDRESS", and press the key.
• The MAC address currently used with this
machine is displayed.
• When you have finished the check, press the
[ENTER] key.
6
Press to select "DHCP", and
press the key.
7
Press to select a setting, and
press the key.
• Set Value: ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
8
Press to select "AutoIP", and
press the key.
9
Press to select a setting, and
press the key.
• Set Value: ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press to select "IP ADDRESS",
and press the key.
• Both of DHCP and AutoIP is OFF, you can set IP
Address. For other than above, proceed to the
Step 14.
• After connecting with the network, it takes time
until the IP address is determined. If the IP
address has not been determined, "0.0.0.0" is
displayed.