MIMAKI UCJV300-75 - Setting of Event Mail Function

3-18
Chapter 3 Machine Setting
11
Press to enter the IP address,
and press the key.
12
Press the key.
• The setting items DEFAULT GATEWAY, DNS
ADDRESS and SUBNET MASK will be displayed.
• Both of DHCP and AutoIP is OFF, you can set
DEFAULT GATEWAY/ DNS ADDRESS/ SUBNET
MASK. For other than above, proceed to the Step
14.
13
Press several times to select a setting
item, and press the key.
14
Press to select a setting,
and press the key.
15
Press the key several times to
end the setting.
Setting of Event Mail Function
Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check "Driver / Utility" on the download page at Mimaki
Engineering (https://mimaki.com/download).
Enable the event mail function
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press
(>>)
twice.
3
Press to select "EVENT MAIL",
and press the key.
4
Press to select "MAIL
DELIVERY", and press the key.
5
Press to select "ON", and press
the key.
6
Press the key several times to
end the setting.
Set the event to send an event mail
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press
(>>)
twice.
3
Press to select "EVENT MAIL",
and press the key.
4
Press to select "SELECT
EVENT", and press the key.
5
Press to select an event, and
press again to select ON/OFF.
press the key.
• Set Value: ON/OFF
• When the event set to ON occurs, e-mail is sent.
• When the [ENTER] key is pressed, the SETUP
screen for the next event is displayed.
6
Press the key several times to
end the setting.
• To reflect network setting, once turn off the power
supply and turn it on again.
Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be deliv-
ered due to Internet environment, failure of the machine/ the
power supply, etc. Mimaki has absolutely no responsibility for
any damages or loss resulting from non-delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
Event name Description
PRINT START
Sets sending/not sending of an e-mail
when printing starts.
PRINT END
Sets sending/not sending of an e-mail
when printing ends.
ERROR
Sets sending/not sending of an e-mail
when printing is stopped due to
occurrence of an error.
PLOT START
Select whether an e-mail is sent or not
when cutting starts
PLOT END
Select whether an e-mail is sent or not
when cutting ends
WARNING
Sets sending/not sending of an e-mail
when a warning occurs during printing.
etc.
Sets sending/not sending of an e-mail
when an event other than the above
occurs.