2-5
2
2
2
2
2
Chapter 2 Basic Operation
Adjusting the Positions of the Pinch Rollers to Suit the Media
Adjust the positions of the pinch rollers to suit the width of the media to be set.
This machine feeds the media with the pinch rollers and grit rollers for printing and cutting. The pinch rollers should be
located above the grit rollers.
How to adjust the pinch roller
Move the pinch roller unit to adjust the position of the pinch roller.
Use the pinch roller guide mark for positioning.
• When you set the media, make sure that the pinch rollers lying outside the media do not lie on top of the grit rollers below
them.
Displace the pinch rollers lying outside the media slightly from their normal positions, as shown in illustration "X" under
"How to adjust the pinch roller". Operating the machine with the media not gripped between the pinch rollers and the grit
rollers could wear the pinch roller out.
Pinch roller guide mark
To adjust the pinch roller
from the front side:
To adjust the pinch roller
from the rear side:
Pinch roller unit (top view)
Adjust the pinch roller so that the triangle mark comes between the pinch roller guide
marks.
Pinch roller unit (rear side)
To Next Page
Loading...
