4-14
Chapter 4 Cutting Function
SETUP SUB MENU
The SETUP SUB MENU offer convenient functions that
you can use in cutting.
The following items are available in the sub menus.
Function name Description
UP SPEED
(P.4-15)
This is to set the speed of sheet and
carriage movement when the tool is up.
Setting the speed lower makes the sheet
misalignment reduced at the time of long
sheet feeding.
DUMMY CUT
(P.4-15)
The blade edge is made to turn to a
specific direction before starting cutting,
which allows dummy cutting.
SHEET TYPE
(P.4-15)
Set this according to the weight of the
media you have set. When this is set to
"HEAVY", the maximum cutting speed is
set low.
ADJ PRS OFFSET
(P.4-15)
This is used to expand the value in such
a case as when the beginning and end
part of the cut are left cut.
Vacuum fan
Set the strength of the vacuum fan at
cutting.
Please use "weak" normally.
OVER CUT
(P.4-15)
By over lapping the start point and the
end point arbitrarily, you can make the
media without uncut area.
Curve mode
If the cut line bends, set it to "SLOW".
Although the cutting speed decreases, it
is possible to prevent a bent.
SETUP RESET
(P.4-16)
Reset the setting values to the initial
state.
To Next Page
Loading...
