2-12
Chapter 2 Basic Operation
8
Pull out the roll media.
(1) Open the front cover.
(2) Pull up the clamp lever from the front of the
machine.
(3) Gently pull out the roll media until you feel
slight resistance.
9
Confirm that the roll media is evenly pulled
out, and then lower the clamp lever.
• Pulling several positions of the media lightly,
lower the clamp lever after confirming that the
amount of the roll media pulled out is almost
even.
10
Hold the media with the media press
gently.
• When using thick media, remove the media press
from the media before printing.
• You do not have to use the media press to cut the
media.
11
Set an empty core of the roll media on the
take-up device.
12
Press and then select "ROLL".
• The media width is detected.
• When [MEDIA DETECT] (one of the machine
settings) is set to "MANUAL" ( P.3-15), media
width will not be automatically detected. Enter the
media width by referring to P.2-13 "Setting the
manual media width".
13
When the media width detection is
complete, use to enter the
number of the pinch rollers you are using.
• When the pinch roller number in "MEDIA
DETECT" of the machine setup is set to OFF
( P.3-15), the screen to enter the number of
pinch rollers is not displayed. Proceed to the Step
16.
14
Press the key.
• When [MEDIA RESIDUAL] (one of the machine
settings) is set to "ON” ( P.3-15), you can
display the remaining media entry screen by
pressing the [Enter] key. ( P.2-13)
• When installing the media, make sure that the
right edge of the media is placed on the left side
with respect to the slit line on the platen. Placing
the media rightward of the slit line will make it rise
up if it moves obliquely, and this could cause dam-
age to the head.
• If a media is misaligned to the right of the standard
position, an error message “MEDIA SET POSI-
TION R” is displayed after detecting the media.
Set the media again.
Media
Media
press
Slit line
To Next Page
Loading...
