2-9
2
2
2
2
2
Chapter 2 Basic Operation
Media size and grit rollers (UCJV300-75)
The grit rollers to be used vary depending on the size of the media.
• To feed the media smoothly, select the appropriate grid roller positions so that the media can be held at equally spaced
intervals.
• When the grid rollers to be used are determined, adjust the pinch roller unit by referring to “P.2-5 「How to adjust the pinch
roller」".
• You can use any number of pinch roller units from 2 to 4.
• The pinch rollers at the left and right ends of the media must be located within 10 cm and 2 cm of the ends of the media,
respectively. If they are positioned further from the ends of the media, some part of the media remains uncut.
777 ~ 810mm
962 ~ 752mm
578~ 638mm
364 ~ 424mm
241 ~ 301mm
691 ~ 751mm
616 ~ 676mm
502 ~ 582mm
288 ~ 348mm
165 ~ 225mm
603 ~ 663mm
528 ~ 588mm
414 ~ 474mm
200 ~ 260mm
86 ~ 137mm
777 ~ 810mm
962 ~ 752mm
578~ 638mm
364 ~ 424mm
241 ~ 301mm
691 ~ 751mm
616 ~ 676mm
502 ~ 582mm
288 ~ 348mm
165 ~ 225mm
603 ~ 663mm
528 ~ 588mm
414 ~ 474mm
200 ~ 260mm
86 ~ 137mm
GR1GR1
GR2GR2GR4GR4
GR3GR3
GR5GR5GR6GR6
GR7GR7
GR8GR8
Determine the grid rollers
to be used according to
the size of the media.
The right end of the media should come
within this range.
GR: Grit roller
To Next Page
Loading...
