2-8
Chapter 2 Basic Operation
Media size and grit rollers (UCJV300-107)
The grit rollers to be used vary depending on the size of the media.
• To feed the media smoothly, select the appropriate grid roller positions so that the media can be held at equally spaced
intervals.
• When the grid rollers to be used are determined, adjust the pinch roller unit by referring to “P.2-5 「How to adjust the pinch
roller」".
• You can use any number of pinch roller units from 2 to 5.
• The pinch rollers at the left and right ends of the media must be located within 10 cm and 2 cm of the ends of the media,
respectively. If they are positioned further from the ends of the media, some part of the media remains uncut.
1043 ~ 1100mm
900 ~ 960mm
732 ~ 792mm
576 ~ 644mm
362 ~ 422mm
241 ~ 301mm
967 ~ 1027mm
824 ~ 884mm
656 ~ 716mm
500 ~ 568mm
288 ~ 348mm
165 ~ 225mm
879 ~ 939mm
736 ~ 796mm
568 ~ 628mm
414 ~ 480mm
200 ~ 260mm
85 ~ 137mm
1043 ~ 1100mm
900 ~ 960mm
732 ~ 792mm
576 ~ 644mm
362 ~ 422mm
241 ~ 301mm
967 ~ 1027mm
824 ~ 884mm
656 ~ 716mm
500 ~ 568mm
288 ~ 348mm
165 ~ 225mm
879 ~ 939mm
736 ~ 796mm
568 ~ 628mm
414 ~ 480mm
200 ~ 260mm
85 ~ 137mm
GR1GR1
GR2GR2GR4GR4
GR3GR3
GR5GR5GR6GR6GR7GR7GR8GR8GR9GR9
Determine the grid rollers to be used
according to the size of the media.
The right end of the media should come
within this range.
GR: Grit roller
To Next Page
Loading...
