iv
Maintenance Function .................................................................4-17
Maintenance of Mark Sensor ..........................................................4-17
Perform SAMPLE CUT to Find out the Cause of Cutting Error. ......4-19
Cutting a Medium into Multiple Pieces with a Certain Length .........4-19
Cutting out Data without Register Marks (PC ORIGIN OFFSET) ....4-20
Setting the Scale Adjust ..................................................................4-21
Chapter 5 Maintenance
Maintenance ..................................................................................5-2
When the Machine Is Not Used for a Long Time ..............................5-2
Precautions for Maintenance .............................................................5-2
Cleaning the Exterior Surfaces ..........................................................5-2
Cleaning the Platen ...........................................................................5-2
Cleaning the Media Sensor ...............................................................5-3
Cleaning the Media Press .................................................................5-3
About MAINTENANCE MENU .......................................................5-4
MAINTENANCE MENUs table ..........................................................5-5
Maintaining the Capping Station ....................................................5-6
Cleaning the Wiper and Cap .............................................................5-6
Cleaning the mist filter....................................................................... 5-7
Clean the NCU .................................................................................. 5-8
Washing the Head Nozzle .................................................................5-9
Cleaning of ink discharge passage ...................................................5-9
When the Machine Is Not Used for a Long Time ............................5-10
Cleaning the Ink Head and the Area around It ............................5-12
Nozzle Recovery Function ...........................................................5-13
Reset the set value ..........................................................................5-14
Eliminate Ink Over Flow .............................................................5-14
Automatic Maintenance Function ................................................5-15
Setting the Refreshing Intervals ......................................................5-15
Setting the Cleaning Intervals and Type .........................................5-15
INK FILLING ................................................................................5-16
AIR PURGE .....................................................................................5-16
Replacing consumables ...............................................................5-18
Replacing the wiper .........................................................................5-18
Replacing the mist filter ................................................................... 5-18
If a Waste Ink Tank Confirmation Message Appears ......................5-19
Replace the waste ink tank with another .........................................5-19
Replacing the waste ink tank before the waste ink tank confirmation
message is displayed ......................................................................5-20
Replacing the Cutter Blade .............................................................5-20
Replacing and Adjusting the Cutter Blade ...................................5-21
Replacing the cutter ........................................................................5-21
Adjusting the Cutter Blade ...............................................................5-22
Replacing cutters other than supplied one ......................................5-22
Adjusting blade edge of cutters other than supplied one ................5-22
To Next Page
Loading...
