Chapter 4 Cutting Function
4-3
4
2
2
Area where register marks and designs
can be arranged
The placeable range for the register mark and the image
is as follows.
• Set the start position of the register mark at 100 mm or more
from the media front end.
• Set the end position of the register mark at 110 mm or more
from the media rear end.
• When the data is copied by using RasterLink, make sure to
leave a space of 210 mm or larger at the tail end of the sheet.
Mark Shape:
Type 1
Mark Shape: Type 2
No-plotting area around the register
marks
The area around a register mark (from the mark origin to
the mark size area) is a non-plotting area. There must be
no data plotted and no stains in this area; otherwise, the
origin may be detected incorrectly or a mark read error
could occur.
Incorrect detection example 1
When there is a line outside the register marks
Incorrect detection example 2
When the distance between register marks (TP2 and TP1
or TP4 and TP2) is smaller than the mark length (for Type
2)
Area where cutting is permitted
Available cutting area
110mm or 210mm more
Between 50mm to
3000 mm
20 mm or more
50 mm or more
5mm or more5mm or more
Rear
Front
Area where cutting is permitted
Available cutting area
110mm or 210mm +
(register mark length / 2) or
more
Between 50mm to
3000 mm
50 mm or more
20 mm+ (register mark
length / 2) or more
5mm or more5mm or more
Rear
Front
• If the mark origin is detected incorrectly, cutting will
be performed in the wrong area.
Mark length
register mark: Type 1
No-plotting area
Mark
Mark Origin
register mark: Type 2
Mark length
No-plotting area
No-plotting
area
Mark Origin
Mark origin detected
incorrectly
Space larger
than the mark
length
Space larger
than the mark
length
To Next Page
Loading...
