Chapter 5 Settings
110
Item Setting Details
*1 *2
• ON: Print data area
Unidirectional print Bi-directional print
Print data
Carriage movement
• Media width: Media size area
(This is supported in firmware version
2.8 and later)
Unidirectional print Bi-directional print
Media
Carriage movement
OVER PRINT HOST/1 to 9
times
1 Sets the number of overprinting.
DRYING TIME - - Sets the drying time.
Scan HOST/0.0 to
9.9 sec
0
sec
Sets the ink drying time after the carriage is paused each time
scanning is completed.
PRINT END HOST/0 to
120 mins
0
min
Sets the drying time after printing.
Margin/Left HOST/-10 mm
to 85 mm
0
mm
Sets the offset value from the media left and right standard
margins (15 mm).
• The left and right margins should be set to at least -5 mm when
using the media holder. This eliminates the risk of printing on top
of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the user to
specify margins. If the machine is set to “HOST”, the offset value
will be “0 mm” for the left and right margins.
Margin/Right
Vacuum HOST/Weak/
Standard/
Strong
Stro
ng
Sets the force with which the medium is held down.
• This can be used to prevent media jamming and print head
damage caused by the media lifting up.
Feed Speed
*3
HOST/10 to
100 to 200 %
100
%
Sets the media feed speed.
• Depending on print conditions, the speed may not vary for
certain settings.
Auto Cleaning - - Sets the conditions to perform auto head cleaning after the
preset number of files are printed.
SETUP File/Length/
Time/OFF
- Sets the conditions to perform auto head cleaning.
Interval - - Sets auto head cleaning intervals.
(File) 1 to 1,000 - Sets the interval at which the number of files is selected.
(Length) 0.1 to 100.0 m - Sets the interval at which the print length is selected.
To Next Page
Loading...
