Chapter 5 Settings
118
Item
Setting
*1
Details
• OFF: The “host” takes priority. Set this to "OFF" when configuring pinch
roller pressure settings on this machine.
"Setting the Pressure and Number of Pinch Rollers to Use"(P. 67)
LANGUAGE English/日本
語/中文/
Turkce
Sets the display language.
Time Set +4 h to 0 to
-20 h
Sets the current time and date. (With respect to JST)
• This can be set within the range of -20 to +4 hours.
UNIT / TEMP °C (Celsius)/
°F
(Fahrenheit)
Sets the display unit for temperature.
UNIT / LENGTH mm/inch Sets the display units for length and area.
• Some items are displayed in “mm” even if “inch” is selected.
Key Buzzer ON/OFF Sets an audible tone when keys are pressed.
• Audible signals indicating errors, warnings, and operation end cannot be
muted, even if “OFF” is selected for this setting.
View Feed ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
Space Feed Mode Intermittent/
Continuous
Alters the feed method for blank space included in the image data.
• Intermittent: Uses intermittent feeding based on the timing of a fraction
of the pass.
• Continuous: Feeds forward by skipping blank parts.
Network - Sets the network address.
The machine must be restarted to enable this setting.
Check IP
Address
- Displays the machine’s current IP address.
• It may take some time to determine the IP address. If the IP address
cannot be determined, the display will indicate “0.0.0.0”.
Check MAC
Address
- Displays the machine’s current MAC address.
DHCP ON/OFF Select “ON” to use the IP address assigned by the DHCP server.
AutoIP ON/OFF Select “ON” to use the IP address set by the AutoIP protocol. Note
that DHCP takes priority if DHCP is set to “ON”.
IP Address
*2
- Sets the machine’s IP address.
Default
Gateway
*2
- Sets the machine’s default gateway.
DNS Address
*2
- Sets the machine’s DNS server address.
Sub Net Mask
*2
- Sets the number of subnet mask digits used by this machine.
Event Mail - An email can be sent to a specified email address when an event
(e.g., print start, print end, and abort) occurs. The machine must be
restarted to enable this setting.
"Event Email Function Settings"(P. 119)
Mail Delivery ON/OFF Sets whether event emails are sent.
Select Event -
Print Start
Event
ON/OFF Sets whether an email is sent when printing starts.
To Next Page
Loading...
