MIMAKI UCJV300 Series - Page 119

Chapter 5 Settings
119
Item
Setting
*1
Details
Print End
Event
ON/OFF Sets whether an email is sent when printing ends.
Plot Start
Event
ON/OFF Sets whether an email is sent when cutting starts.
Plot End
Event
ON/OFF Sets whether an email is sent when cutting ends.
Error ON/OFF Sets whether an email is sent when an error occurs.
Warning ON/OFF Sets whether an email is sent when a warning occurs.
Other Event ON/OFF Set to send or not send an email when an event other than those
listed above occurs.
Mail Address - Sets the email address to which emails will be sent (not to exceed 96
alphanumeric characters or symbols).
Message Subject - Sets the characters contained in a message subject (not to exceed 8
alphanumeric characters or symbols).
Server Setup -
SMTP
Address
- Sets the SMTP server.
SMTP Port
No.
- Sets the SMTP port number.
Sender
Address
- Sets the sender address (not to exceed 64 alphanumeric characters
or symbols).
• Setting an email address corresponding to the server account allows
emails to be sent.
Authentication OFF/POP
before SMTP/
SMTP
authentication
Sets the SMTP server authentication method.
User Name
*3
- Sets the user name used for authentication. (Not to exceed 30
alphanumeric characters or symbols)
Pass Word
*3
- Sets the password used for authentication. (Not to exceed 15
alphanumeric characters or symbols)
POP3
Address
*4
- Sets the POP server.
APOP
*4
- Enables or disables APOP.
Transmit Test - Sends a test email.
"Sending Test Email"(P. 120)
Reset - Initializes the details set.
*1. The default settings are shown underlined.
*2. This can be set when both [DHCP] and [AutoIP] are set to “OFF”.
*3. This can be set when [Authentication] is not set to “OFF”.
*4. This can be set when [Authentication] is set to “POP before SMTP”.
Event Email Function Settings
An email can be sent to a specified email address when an event (e.g., print start, print end, and abort)
occurs.
5