Chapter 6 Maintenance
145
10
Fill the cap with washing liquid.
• Use a syringe to draw up some washing liquid and fill until it almost overflows from the cap.
11
Press the [ENTER] key.
• The pump tube (ink discharge channel below the cap) is washed. “Please wait” appears on the
display.
• Pump tube washing takes approximately one minute.
12
Close the front cover, then press the [ENTER] key.
• Do not turn off the main power supply. Turning off the main power supply will disable the
automatic maintenance function (including the nozzle clogging prevention function and ink
discharge channel cleaning function) and may result in printing defects (such as nozzle clogging
and deflection) or other faults.
• Do not leave media loaded on the platen. This may leave irregularities or ripples in the media.
• When this product is not in use, raise the clamp lever to separate the pinch rollers from the grid
rollers. If the pinch rollers are left in the lowered position for an extended period of time, they
may become deformed, possibly preventing the media from being fed correctly.
• Perform the following if the “Check Waste Ink Tank” message appears on the display.
"Waste Ink Tank Replacement"(P. 155)
6
To Next Page
Loading...
