MIMAKI UCJV300 Series - Checking the LAN Connection and Network Precautions

Chapter 1 Before Using This Product
37
l
Checking the LAN connection
1
Check the display on this product.
• Local guidance can be used for checking.
"Displaying Machine Information (Local Guidance)"(P. 31)
• Printing is not possible if “100Mbps”, “10Mbps”, or “No Connect” is displayed. Event email can be
used.
"Event Email Function Settings"(P. 119)
INFORMATION
LAN Status 1000Mbps
2
Check the lamp on the LAN connector.
• The LAN connector lamp illuminates when this machine is running.
Color Status Description
Green Illuminated Connected via 1000BASE-T
Off Connected via a network other than 1000BASE-T
• 1,000 Mbps is not supported if only the orange lamp is illuminated or flashing.
Check the specifications for the PC, peripheral devices, and cable.
Orange Illuminated Linked up (connected).
Flashing Data being received
Off Link down (not connected)
Network Connection Precautions
Make sure the network is set up as follows: Printing is not possible if the network is not set up correctly.
• Use a Category 6 or higher LAN cable.
• Use a 1000BASE-T compatible computer or switching hub. Printing requires 1000BASE-T support.
• The PC used to transfer print data must be located on the same network as this product. This product
cannot be connected via a router.
l
Direct connection to the product
l
Connection via a switching hub
Switching hub
1