MIMAKI UCJV300 Series - Roll Media Loading Steps

Chapter 2 Printing
60
2
Move the rear left roll holder to the roll setting position.
• Unscrew the roll holder retaining screw before moving.
3-inch core mounting position
2-inch core mounting position
Align the roll holder with the pinch roller guide mark.
3
Tighten the retaining screw on the rear left roll holder.
4
Place roll media on the roll media hanger.
5
Attach the core of the roll medium to the rear left roll holder.
• Push until the core moves no farther.
6
Insert the rear right roll holder into the core.
• Unscrew the roll holder retaining screw before moving.
7
Tighten the retaining screw on the rear right roll holder.
8
Insert the medium.
• Insert into the gap between the pinch roller and the grit roller.
• Inserting media at an angle allows smooth insertion without catching or sticking.