Chapter 2 Printing
61
9
Lower the clamp lever.
• Hold the media with the pinch roller and grid roller.
10
Move to the front of the machine and open the front cover.
11
Raise the clamp lever and pull out the medium.
• Make sure the medium does not fall to the rear.
• Adjust the rear roll holder position so that the medium does not cover the right-hand slit
line on the platen. Movement at an angle may result in damage to the print head.
Slit line
Media
Media holder
• The areas extending 5 mm from both sides of the media are margins.
12
Lower the clamp lever to confirm that the spacing from the pinch roller is uniform.
• "Adjusting the Pinch Roller Positions"(P. 54)
• If not, repeat all steps from the start.
13
Raise the clamp lever.
14
Gently pull out the medium and stop at the position where it is gently locked in place.
2
To Next Page
Loading...
