Chapter 2 Printing
65
2
Raise the clamp lever.
3
Open the front cover.
4
Insert the medium.
• Insert into the gap between the pinch roller and the grit roller.
• Inserting media at an angle allows smooth insertion without catching or sticking.
5
Adjust the position of the right media edge.
• Set the media straight so that the media does not lie beyond the slit line on the platen.
First three grit rollers from the right end on the front of the machine
• The areas extending 5 mm from both sides of the media are margins.
6
Adjust the position of the front media edge.
• Set the media so that at least 40 mm of the media lies on the after cover. If not, the media width
may not be detected.
Media After cover
About 40 mm
7
Lower the clamp lever to confirm that the spacing from the pinch roller is uniform.
• Hold the media with the pinch roller and grid roller.
• "Adjusting the Pinch Roller Positions"(P. 54)
2
To Next Page
Loading...
