MIMAKI UCJV300 Series - Installing Ballpoint Pen in Pen Holder

Chapter 3 Cutting
87
4
Fix the cap by turning in the direction indicated by the arrow in the picture.
Installing a Ballpoint Pen in the Pen Holder
Use a ballpoint pen with a diameter of 8 to 9 mm. The ballpoint pen type may affect image quality.
Recommended: K105-GA (Pentel Co., Ltd.)
• Do not use ballpoint pens as shown below. Some types of ballpoint pens may tilt.
Pens with shafts that
change thickness
midway
Pens with protrusions or
bumps on the shaft
1
Put the cap on the pen adapter.
• The cap is used to adjust the height of the pen nib.
Pen adapter
Cap
2
Insert the ballpoint pen into the pen adapter.
• Insert the pen nib until it hits the cap.
Ballpoint pen
3