MIMAKI UCJV300 Series - Installing a Pen

Chapter 3 Cutting
88
3
Fix the pen nib by turning the knob screw in the direction indicated by the arrow in the
picture.
• Be careful to avoid overtightening the knob screw. Disregarding this precaution may damage or
break the ballpoint pen.
Knob screw
4
Remove the cap.
Installing a Pen
1
In LOCAL mode, select [MENU] > [CUTTING], then press the [ENTER] key.
• The Cutting menu is displayed.
2
Select [TOOL CHANGE], then press the [ENTER] key.
• The cutter unit moves over the platen.
3
Open the front cover.
• The cutter unit can be moved manually. Move the cutter unit slowly to a position that easy access
for installing the cutter holder.