Chapter 1 Before Use
1-12
7
Set the ink bottle on the tank.
• Set the ink bottle while moving the lever on the
tank completely to the right.
8
Move the lever on the tank completely from
the right to the left side.
Replace the ink bottle
Perform as follows when [INK END] or [INK NEAR END]
is displayed on the display.
When [INK END] is displayed
1
Move the lever on the tank completely from
the left to the right end.
2
Lift out the ink bottle while keeping it
completely straight.
• Do not ever rotate the ink bottle at all after setting
it into the tank.
Doing so can result in ink leakage.
• Check for dust or debris on the cap before setting
the bottle. If any paper or dust adheres to the cap,
it may cause a clogged path defection.
• Do not ever rotate the ink bottle at all after setting
it into the tank. Doing so can result in ink leakage.
• Check that the light-blocking cover closes when
removing the ink bottle from the tank. Close by
hand if the cap does not close. Leaving the light-
blocking cover open can result in the ink curing.
To Next Page
Loading...
Need help?
General