3-12 TM80 Telemetry Monitor Service Manual
No. Item Requirements of the TM80 Description
connected to this AP is 16, then the
announced number of devices than
can connect to AP simultaneously
must be more than 32.
2. The AP Can create several SSIDs.
3 Device density The maximum number of devices
connected to one AP simultaneously
is 16 (including TM80 and other
devices).
The
requirement
must be met.
4 AP
compatibility
When customer using APs not from
Cisco, compatibility test should be
passed
The
requirement
must be met.
3.2.1.3 Requirements for WLAN Features
The requirements of the TM80 for WLAN features are as follows. If WLAN is of other
features, e.g. using 802.11ac, TM80 will not support, and can't connect to network.
The TM80 adopts low power consumption Wi-Fi technology. If the amount of
broadcast or multicast data is too large on the network, the device wake-up time
increases, the standby duration is shortened, and even Wi-Fi transmission
interruption is caused. Therefore, the TM80 must use an independent VLAN and
work in a different network segment from the CMS, so as to control the amount of
broadcast data. An AP can be configured with multiple SSIDs and associated with a
VLAN. The TM80 needs to use an independent SSID.
To Next Page
Loading...
Need help?
General
