TM80 Telemetry Monitor Service Manual 3-13
No. Item Requirements of the TM80 Description
1 802.11
protocol
TM80 only support 802.11 a/b/g/n,
WLAN can't use other protocols
The requirement
must be met.
2 Security
mode
TM80 supports:
WPA/WPA2-PSK or WPA2-Enterprise
EAP method:
PEAP-GTC, PEAP- MSCHAPv2,EAP-TLS
WPA2-PSK is highly recommended.
WPA2-Enterprise may increase
probability of offline when roaming, so
not be recommended.
WLAN can't use other security mode.
The requirement
must be met.
3 AP MAC
address
The broadcast MAC address of AP is
fixed (BSSID).
AP BSSID is used to locate the TM80
device. If it is changed, failure to locate
the TM80 may occur.
The requirement
must be met.
4 AP channel
width
If the AP supports 802.11n/ac, set the
channel width to 20Mhz, don’t use HT40
or even HT80.
The requirement
must be met.
5 Dedicated
VLAN
The TM80 needs to work on a dedicated
VLAN.
Using VLAN can minimize Broadcast or
multicast data which can affect TM80
stability.
The requirement
must be met.
To Next Page
Loading...
Need help?
General
