TM80 Telemetry Monitor Service Manual 3-31
3.3.5.1 Setting 802.11b/g/n (2.4G)
Network Settings
On the page, enable 2.4G and configure the data rate.
1. Choose WIRELESS→802.11b/g/n→Network. The configuration page is
displayed.
2. Perform the following configuration on the page.
802.11b/g Network Status=Enabled
802.11g=Enabled
Data Rates: Set 1Mbps, 2Mbps, 5.5Mbps, and 11Mbps to
Mandatory and other items to Supported.
The figure below shows the specific Network configuration.
3. Click Apply and Save Configuration.
RRM Settings
The RRM provides multiple algorithms and can automatically adjust the transmit
power, channel number, and coverage according to the wireless environment to
optimize the wireless environment.
To Next Page
Loading...
Need help?
General
