14 REMOTE OPERATION
14.1 Remote RUN/STOP
125
14
• When set to RUN at contacts OFF
When contact is set to OFF, the CPU module is in the RUN status.
When contact is set to ON, the CPU module is in the STOP status.
Engineering tool method
Refer to the following.
GX Works3 Operating Manual
Method using external devices that use SLMP or MC protocol
Execute by SLMP or MC protocol 1C/3C/4C frame command. For details on commands, refer to the following manual.
MELSEC iQ-F FX5 User's Manual (Communication)
Describes the precautions on using remote RUN/STOP.
• When remote RUN is performed during execution of the data logging function, it may fail. In that case, wait for a while and
retry remote RUN. If remote RUN still cannot be executed, check whether remote RUN is acceptable and retry remote
RUN. (Page 192 About remote operation)
• When remote STOP to RUN operation of the RUN contact during execution of the data logging function, it may take time to
return to the RUN state.
Step 0 ENDStep 0 END
ON
OFF
STOP
RUN
STOP status
RUN contact
RUN/STOP status
RUN
OFF
Step 0 ENDStep 0 END
ON
ON
OFF
STOP
STOP status
Remote RUN command
Remote STOP command
RUN/STOP status
External Device
To Next Page
Loading...
