Mitsubishi Electric MELSEC iQ-F FX5 - High-speed comparison table

25 HIGH-SPEED INPUT/OUTPUT FUNCTION
25.1 High-speed Counter Function
257
25
High-speed comparison table
The high-speed comparison table is explained below.
Used to set high-speed comparison table for high-speed counters.
Parameter setting
Sets match output setting for high-speed counters.
■CPU module
Navigation window  [Parameter]  [Module model name]  [Module Parameter]  [High Speed I/O]  "Input
Function"  "High Speed Counter"  "Detailed Setting"  "High Speed Compare Table"
Window
Displayed items
■High-speed pulse input/output module
Add the high-speed pulse input/output module.
Navigation window  [Parameter]  [Module Information]  Right-click  Add New Module
After adding the high-speed pulse input/output module, make settings on the screen displayed from the following operation.
Navigation window  [Parameter]  [Module Information]  [1 to 16 (high-speed pulse input/output module)] 
[Module Parameter]  "Input Function"  "High Speed Counter"  "Detailed Setting"  "High Speed Compare Table"
Item Description Setting range Default
Counter CH Set the counter CH of coincidence output target. Disable, CH1 to CH8 Disable
Comparison Type Set comparison type. • Set
•Reset
• Self Reset
• Band Area Comparison
Set
Output Destination Device Sets output destination device for output comparison results of
comparison value 1 and comparison value 2.
Bit device (Y, M), Interrupt pointer (I16 to
I23)

Comparison Value 1
Specification Method
Sets the specification method of comparison value 1. • Direct Specification
• Indirect Specification
Direct
Specification
Comparison Value 1 Direct Sets value (comparison value 1) to be compared with current value
of high-speed counter. (When direct specification is selected)
-2147483648Comparison value
1+2147483647
0
Comparison Value 1
Indirect
Sets device (comparison value 1) to be compared with current value
of high-speed counter. (When indirect specification is selected)
Word device (D, R) 
Comparison Value 2
Specification Method
If band comparison is set to comparison type, sets the specification
method of comparison value 2.
• Direct Specification
• Indirect Specification

Comparison Value 2 Direct If band comparison is set to comparison type, sets value
(comparison value 2) to be compared with current value of high-
speed counter. (When direct specification is selected)
Comparison value 1Comparison value
22147483647

Comparison Value 2
Indirect
If band comparison is set to comparison type, sets device
(comparison value 2) to be compared with current value of high-
speed counter. (When indirect specification is selected)
Word device (D, R) 