APPX
Appendix 8 How to Use CPU Module Logging Configuration Tool
855
A
Appendix 8 How to Use CPU Module Logging
Configuration Tool
This appendix describes how to operate the CPU Module Logging Configuration Tool and configure the logging function.
For the system configuration and procedure for using the data logging function, refer to the following.
Page 153 Procedure for Using
Operating environment
For details on the operating environment for CPU Module Logging Configuration Tool, refer to following manual which is
stored in the installer.
CPU Module Logging Configuration Tool/GX LogViewer Installation Instructions (BCN-P5999-0506)
Installation/uninstallation
For the procedures for installing and uninstalling the CPU Module Logging Configuration Tool, refer to the following.
CPU Module Logging Configuration Tool/GX LogViewer Installation Instructions (BCN-P5999-0506)
Starting the CPU Module Logging Configuration Tool
The CPU Module Logging Configuration Tool can be started by the following three methods.
■Starting from the Start menu
After installing the CPU Module Logging Configuration Tool, you can start the tool by the following operation.
[Start] [All Programs] [MELSOFT] [Logging Function] [CPU Module Logging Configuration Tool]
■Starting from GX Works3
After starting GX Works3, you can start the tool by the following operation.
[Tool] [Logging Configuration Tool]
When the tool is started, the project information (connected device, transfer setup/setting, and display language) of GX
Works3 is handed off.
■Starting from GX LogViewer
Refer to the following manual.
GX LogViewer Version 1 Operating Manual
If an error message is displayed when the CPU Module Logging Configuration Tool is started, start it with
administrator privileges.
To Next Page
Loading...
