850
APPX
Appendix 6 Event List
Event list
The following table lists events related to the CPU module.
Event
code
Event
type
Event
category
Detected event Description Detailed information
Detailed
information
1
Detailed
information
2
Detailed
information
3
00430 System Info SFC program continue
start not possible
An SFC program could not be resumed,
and an initial start was performed.
00800 Warning Link-down The CPU module has entered into the
link-down state as a result of an
operation such as disconnecting a
network cable between the CPU module
and an external device.
Operation
source
information
Communication
speed and
communication
mode
00904 Socket communication
send error
Sending a message over socket
communication failed.
01000
and after
Error When a self-diagnostic error occurs, the error is stored as an event.
10100 Security Info Security key
registration/deletion
A security key was registered or deleted. Operation
source
information
Security key
operation
information
10200 Remote password lock The remote password was set. Remote
password
information
10201 Remote password
unlock
The remote password unlock processing
was successfully completed.
10202 Remote password
unlock failed
The remote password unlock processing
failed.
10300 Access from an IP
address blocked by
the IP filter setting
An access from an IP address blocked by
the IP filer setting was accepted.
Blocked IP
address
information
10400 File password
registration/change/
deletion
A file password was successfully
registered, changed, or deleted.
File password
information
10401 File password
registration/change/
deletion failed
Registration, change, or deletion of a file
password failed.
10402 File password unlock A file password was successfully
unlocked.
10403 File password unlock
failed
Unlock of a file password failed.
20100 Operation Info Error clear The error was cleared. Operation
source
information
20200 Event history clear The event history was cleared.
20210 Scan time clear The scan time was cleared.
20400 Firmware update
successful via SD
memory card
CPU module firmware update using the
SD memory card was performed and
completed successfully.
CPU module
firmware
update
information
20401 Firmware update
failed via SD memory
card
CPU module firmware update using the
SD memory card was performed and was
not completed successfully.
24000 Clock setting The clock data was set. Operation
source
information
24001 Remote operation
request accepted
A remote request (RUN, STOP, or
PAUSE) was accepted.
Remote
operation type
information
24200 Creation of new
folders, writes to files/
folders
A new folder was created.
A new file was created or data was
written to a file.
Drive/file
information
2A200 Warning Memory initialization The memory was initialized. Drive/file
information
2
A201 Device/label zero clear Values in a device or label were cleared
to zero.
Device/label
information
2A202 Folder/file deletion A folder or file was deleted. Drive/file
information
To Next Page
Loading...
