Mitsubishi Electric MELSEC iQ-F FX5 - 6.3 Device;Label Memory Area Setting

6 CAPACITY SETTING OF EACH AREA IN DEVICE/LABEL MEMORY
6.3 Device/Label Memory Area Setting
83
6
6.3 Device/Label Memory Area Setting
The capacity of each data area allocated within the device/label memory can be changed.
Navigation window  [Parameter]  [Module model name]  [CPU Parameter]  "Memory/Device Setting"  "Detailed
Setting"  "Device/Label Memory Area Setting" window
Operating procedure
Displayed items
(1) Whether or not to use an option battery, and latch area setting for the latch type label can be changed.
Only FX5U/FX5UC CPU module is supported.
(2) The device/label memory area capacity can be set.
*1 For details on the setting range for each area capacity, refer to Page 82 The Setting Range of the Capacity of Each Area.
High-speed area: Area which can be accessed at high speed. Latch is always held by nonvolatile memory.
Standard area: Area which can be held when option battery is used. In addition, about a latched type label,
when a latch area is set as a standard latch area, latch type label is held by nonvolatile memory.
"Device/Label Memory Area Setting" window
1. In "Option Battery Setting", select whether or not
to use a option battery. (Only when the option
battery is used)
2. In "Device/Label Memory Area Setting" window,
set the capacity of each area.
Items Description Setting range Default
Option Battery Setting Set when using option battery. The points which can be held can be
increased by this setup.
• Not Mounted
• Mounted
Not Mounted
Latch area of the latch label The latch device of standard area can be held with a battery. The
latch area of latch label can be changed to battery latch area from
standard latch area (nonvolatile memory).
• Standard Latch Area
• Battery Latch Area
Standard Latch Area
Items Label Device
High-speed Area Label:
Set label area capacity used in the global label, local label.
*1
Latch:
Set the latch label area capacity used for the latch type label.
*1
Set the capacity of device (standard) area. The
number of device points in the detail settings, and
the latch settings can be changed. For details, refer
to Page 84 Device Setting.
Standard Area
(2)
(1)