35 CPU MODULE BUILT-IN ANALOG FUNCTION
35.6 Function (PID Control Via Parameter)
635
35
Usage procedure
This section describes the flow of using the PID control via parameter function as follows. Details are explained per control
mode.
1. Configure "Heating/Cooling PID Control Setting" with GX Works3 CPU parameters. (Page 638 Parameter setting)
2. Create a program. (Page 641 Programming)
3. Write the parameters to the CPU module. (Page 641 Operation)
4. Set the CPU module to the STOP state and to the RUN state, and turn the PID control execution command on.
(Page 641 Operation)
To Next Page
Loading...
