Mitsubishi Electric MELSEC iQ-F FX5 - 24 MEMORY CARD FUNCTION; 24.1 SD Memory Card Forced Stop

24 MEMORY CARD FUNCTION
24.1 SD Memory Card Forced Stop
229
24
24 MEMORY CARD FUNCTION
The following explains the functions that use SD memory card.
If an SD memory card is used on the FX5S CPU module, the SD memory card module is required.
24.1 SD Memory Card Forced Stop
SD memory card can be disabled without turning power ONOFF, even when a function that uses SD memory card is being
executed, such as when the data logging function is running.
Methods of SD memory card forced stop
The methods of SD memory card forced stop are as described below.
■Operation by SD memory card disable switch
1. Press the SD memory card access control switch for 1 second or longer.
* 1
2. The CARD LED will flash on  turn off.
* 1*2
3. Remove the SD card.
*1 For the SD memory card module, slide and hold the SD memory card access control switch to OFF (upward) for 1 second or longer.
*2 If there is a function accessing the SD memory card, the CARD LED will flash off after the access of that function is complete. Therefore,
the time from flash on to flash off will be different depending on the function.
■Operation by special relay
1. Turn ON SM606 (SD memory card forcibly disable command).
2. Check if CARD LED has turned off or SM607 (SD memory card forcibly disable status flag) has turned ON.
3. Remove the SD card.
ON
OFF
ON
OFF
SM606 (SD memory card
forcibly disable command)
SM607 (SD memory card
forcibly disable status flag)