25 HIGH-SPEED INPUT/OUTPUT FUNCTION
25.3 Pulse Width Measurement Function
309
25
Pulse width measurement complete
This flag turns ON at the end of the 1st pulse width measurement. During measurement in the always measurement mode, it
stays ON.
■Corresponding devices
The device numbers corresponding to each channel are as follows.
■Update timing
Devices are updated by the END instruction.
■Clear timing
The timing when the device is cleared is as follows.
•Power OFFON
• Reset
•STOP/PAUSERUN
• The first END instruction after measurement is started by the HIOEN/DHIOEN instruction
When the HCMOV/DHCMOV instruction is used, the latest value can be read.
Measurement mode
The measurement mode can be checked. The measurement mode can also be changed by turning special relays ON/OFF.
OFF: Always measurement mode
ON: 1 time measurement mode
Measurement mode is applied when measurement is started by the HIOEN/DHIOEN instruction.
If the measurement mode is changed during measurement, operation in the measurement mode after the
change begins when the next measurement is started.
■Corresponding devices
The device numbers corresponding to each channel are as follows.
■Clear timing
The timing when the device is cleared is as follows.
•Power OFFON
• Reset
•STOP/PAUSERUN
CPU module High-speed pulse input/output module
First module Second module Third module Fourth module
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12
SM5052 SM5053 SM5054 SM5055 SM5056 SM5057 SM5058 SM5059 SM5060 SM5061 SM5062 SM5063
CPU module High-speed pulse input/output module
First module Second module Third module Fourth module
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12
SM5068 SM5069 SM5070 SM5071 SM5072 SM5073 SM5074 SM5075 SM5076 SM5077 SM5078 SM5079
To Next Page
Loading...
