Mitsubishi Electric MELSEC iQ-F FX5 - Page 389

30 POSITIONING PARAMETER
30.2 Details of Parameters
387
30
Position Data Magnification
Setting method: High Speed I/O Parameter
The values of positioning addresses can be multiplied by the Position Data Magnification. The available multiplying factors
include single, 10 times, 100 times, and 1000 times. The following shows a setting example.
Ex.
For magnification by 1000 times
For the positioning address of 123, the following shows the actual address and transfer distance.
• Motor System unit: 123  10
3
= 123000 [pulse]
• Machine/Multiple System unit: 123  10
3
= 123000 [m, 10
-4
inch, mdeg] = 123 [mm, 10
-1
inch, deg]
The following table lists the relation between the positioning data magnification of each unit system.
Position Data
Magnification
Unit system setting (position unit) Unit system setting (speed unit)
pulse m 0.0001 inch mdeg pps cm/min inch/min 10 deg/min
Single pulse m  0.0001 inch mdeg pps cm/min inch/min  10 deg/min
10 times  10 pulse  10 m  0.001 inch  10 mdeg
100 times  100 pulse  100 m  0.01 inch  100 mdeg
1000 times  1000 pulse mm  0.1 inch deg