Mitsubishi Electric MELSEC iQ-F FX5 - Page 663

35 CPU MODULE BUILT-IN ANALOG FUNCTION
35.6 Function (PID Control Via Parameter)
661
35
■Parameter setting example
Setting item Setting value Device indirect specification
Basic
Settings
To Use or Not to Use PID Control Function Use 
Control Mode Selection Standard PID Control 
Direct Action/Reverse Action Selection Reverse Action 
Target Value (SV) 500 D0
Process Value (PV)  SD6300
Output Value (MV)  D1
Heating Output Value (MVh) 
Cooling Output Value (MVc) 
Control Parameter Proportional Gain (KP) Not used D200
Heating Proportional Gain
(KPh)

Cooling Proportional Gain
(KPc)

Integral Time (TI) Not used D203
Derivative Time (TD) Not used D204
Sampling Time (Ts) 10[10ms] Not used
Operation Cycle Control Output Cycle 50[100ms] Not used
Heating Control Output
Cycle

Cooling Control Output
Cycle

Control Output  Y1
Control Output (for Cooling Control) 
PID Control Execution Command  X0
To Use or Not to Use Auto-tuning  X1
PID Control Execution Status  M0
Auto-tuning Execution Status  M1
PID Control Function Error Display  Y0
PID Control Function Error Code  D10
Application
Settings
2-position Control Function Adjustment sensitivity
(dead band)
10 Not used
Overlap/Dead Band Setting 
Output Limiter Function Upper Limit Output Limiter 900[0.1%] Not used
Lower Limit Output Limiter 0[0.1%] Not used
Heating Upper Limit Output
Limiter

Cooling Upper Limit Output
Limiter

Output Variation Rate
Limiter Function
Output Variation Rate
Limiter
0[0.1%/s] Not used
Temperature Rise
Completion Judgement
Function
Temperature Rise
Judgment Flag
 M3
Temperature Rise
Completion Range
50 Not used
Temperature Rise
Completion Soak Time
5[s] Not used
A
mbient Temperature Setting 