Mitsubishi Electric MELSEC-Q Series - Page 212

210
(d) Refresh parameters of a Basic model QCPU or safety CPU station
Refresh only the LB/LW used for the CPU module because the B/W capacity of the CPU module (2K points) is
too small.
Ex.
When data refresh is performed with station No.1 only, and not with station No.2 and No.3
• Refresh parameters of station No.4
Remark
The internal user device of the CPU module can be changed in the PLC parameter of the programming tool.
User's Manual (Function Explanation, Program Fundamentals) for the CPU module used
0 to 3FF
Control station
No.1
Normal station
No.2
Normal station
No.3
Normal station
No.4
CPU module
CC-Link IE Controller
Network module
400 to 7FF
800 to BFF
C00 to FFF
0 to 3FF
400 to 7FF
0 to 3FF
400 to 7FF
7FFF
0 to 3FF
400 to 7FF
W
800 to BFF
C00 to FFF
1FFFF
LW
BLB
Station No.4Station No.4Station No.4
Station No.4Station No.4Station No.4
Station No.1Station No.1Station No.1
Station No.4Station No.4Station No.4
Station No.1Station No.1Station No.1
Station No.1Station No.1Station No.1
Station No.2Station No.2Station No.2
Station No.3Station No.3Station No.3
Station No.4Station No.4Station No.4
Station No.1Station No.1Station No.1
Station No.2Station No.2Station No.2
Station No.3Station No.3Station No.3