Mitsubishi Electric MELSEC-Q Series - Page 213

211
CHAPTER 6 PARAMETER SETTING
6
6.5 Refresh Parameters 6.5.1 Refresh parameter setting
(2) Checking the refresh parameters assignment image
The refresh parameters assignment image for the network modules can be viewed in the network parameters of
the programming tool.
1. Open the "Setting the number of MELSECNET/CC IE/Ethernet Module Configuration" window in
the programming tool. ( Page 180, Section 6.2)
2. Click the button.
3. Set "Device (PLC Side)", "Device (Link Side), and "Display Magnification" to display the
assignment image.
If any CPU-side device area is duplicated (red), check the refresh parameters.