Mitsubishi Electric MELSEC-Q Series - Page 426

424
• When failed
(4) Error
When a link dedicated instruction failed, the error details can be confirmed by either of the following methods.
(a) With the programming tool
The error details can be checked in the CC IE Control diagnostics. ( Page 526, Section 10.3)
(b) Checking devices
An error code is stored in Completion status ((S1)+1) of control data.
Check the error and take corrective actions according to the error code. ( Page 511, Section 10.2)
Error code
RECVS
Interrupt program
Sequence scan
Own station CPU
CC-Link IE Controller
Network module
Completion status
(Device of ((S1)+1)
END END
Channel 3
END
IRET
0 END0 END0