425
CHAPTER 9 DEDICATED INSTRUCTIONS
9
9.11 Z.RECVS (Data Reception from Programmable Controllers on Other Stations)
(5) Program example
The following is a program in which, when an interrupt program is started, data sent from station No.1 by the
SEND instruction are read out from channel 5 into D770 to D773.
• SEND instruction: Page 400, Section 9.9
(a) System configuration example
(b) Parameter setting ( Page 225, Section 6.6)
• Interrupt setting
• Intelligent function module interrupt pointer setting
(c) Devices used in the program example
• Special relay (SM)
• Devices used by the user
Device Description Device Description
SM400 Always ON —
Device Description Device Description
M165 Dummy
D770 to
D773
Receive data storage device
D370 to
D379
Control data —
RECVS
SM400
IRET
I50
Station No.2
Network No.1
CC-Link IE Controller
Network module
Station No.1
CC-Link IE Controller
Network module
CPU module CPU module
Channel 2
Channel 1
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
Channel 2
Channel 1
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
SEND
To Next Page
Loading...
