Mitsubishi Electric MELSEC-Q Series - Page 481

479
CHAPTER 9 DEDICATED INSTRUCTIONS
9
9.18 Z(P).UINI (Station No. Setting of Own Station)
(5) Program example
In the following program, when M1 turns ON, station No.2 is set.
(a) System configuration example
The CC-Link IE Controller Network module is mounted in slot 0 of the base unit.
(b) Parameter setting ( Page 180, Section 6.2)
Select "Specify Station No. by Program" in the network parameters.
Network No.1
Control station
No.1
Normal station
No.4
Normal station
No.3
Normal station,
no station No. set
UINI instruction