624
SB0091 Forward loop status SB0065 Loopback status
(No. changed)
• Although the CC-Link IE
Controller Network uses
two-core cables, loopback
is performed even if a
disconnection or error is
detected on one side.
• The cause of loopback
can be checked by Own
station's loop status
(SW0064).
SB0092
Forward loop status of the
remote master station
—— —
Delete the sequence
program for the
corresponding part.
SB0095 Reverse loop status SB0065 Loopback status
(No. changed)
• Although the CC-Link IE
Controller Network uses
two-core cables, loopback
is performed even if a
disconnection or error is
detected on one side.
• The cause of loopback
can be checked by Own
station's loop status
(SW0064).
SB0096
Reverse loop status of the
remote master station
—— —
Delete the sequence
program for the
corresponding part.
SB0099 Forward loop loopback SB0065 Loopback status
(No. changed)
• Although the CC-Link IE
Controller Network uses
two-core cables, loopback
is performed even if a
disconnection or error is
detected on one side.
• The station No. for the
station where a loopback
is executed can be
checked by IN-side
loopback station No.
(SW0070).
SB009A Reverse loop loopback SB0065 Loopback status
(No. changed)
• Although the CC-Link IE
Controller Network uses
two-core cables, loopback
is performed even if a
disconnection or error is
detected on one side.
• The station No. for the
station where a loopback
is executed can be
checked by OUT-side
loopback station No.
(SW0080).
MELSECNET/H CC-Link IE Controller Network
Compatibility
Precautions for
replacement
No. Name No. Name
To Next Page
Loading...
