92
(2) Stopping cyclic transmission
1. Select the target station(s).
*1 Right-clicking on the "All Station Status" window and clicking [Cancel Select All] cancels all the selection.
2. Select the "Link Stop" radio button and click the button.
• By executing "specific station", the cyclic transmission of 1N
S
2 can be stopped.
3. The target station will stop cyclic transmission.
While cyclic transmission is being stopped, the D LINK LED of the target station is flashing.
If cyclic transmission of the station connected to a programming tool (own station) is stopped with this function, the own
station is disconnected from the network and thereby all stations are displayed as faulty stations in the CC IE Control
diagnostics.
When cyclic transmission of the own station is resumed according to Page 93, Section 4.1.12 (3), all of them will change to
normal stations on the display.
Note that, if there is any other station that stops its cyclic transmission, the station will be displayed as a faulty station. (Cyclic
transmission of the station does not restart.)
Target station
Specification method
*1
Specific station
Check the "Selective Status" checkbox of the target station.
Multiple stations can be selected.
Group Right-click on the line of the target group, and click [Group Selection].
All stations Right-click on the "All Station Status" window, and click [Select All].
Cyclic transmission restart
Programming tool
1MP1
1N
S4
1N
S2
1N
S3
To Next Page
Loading...
