93
CHAPTER 4 FUNCTIONS
4
4.1 Cyclic Transmission Function
4.1.12 Stop/restart of cyclic transmission
(3) Restarting cyclic transmission
1. Select the target station(s).
*1 Right-clicking on the "All Station Status" window and clicking [Cancel Select All] cancels all the selection.
2. Select the "Link Start" or "Forced Link Start" radio button and click the button.
• [Link Start]: Allows execution from the station where cyclic transmission was stopped
• [Forced Link Start]: Allows execution from any of all stations.
3. The target station will resume cyclic transmission.
When cyclic transmission is restarted, the D LINK LED of the target station turns on.
● When the target station is powered ON from OFF or when the CPU module is reset, cyclic transmission is also restarted.
● Link start cannot be performed in the following stations.
• A station where cyclic transmission has been stopped due to an error
• A station where a link has been stopped by a command from another station
*1
• A station where a link has been stopped by link special relay (SB) or link special register (SW)
*1
*1 Selecting "Forced Link Start" starts the link.
Target station
Specification method
*1
Specific station
Check the "Selective Status" checkbox of the target station.
Multiple stations can be selected.
Group Right-click on the line of the target group, and click [Group Selection].
All stations Right-click on the "All Station Status" window, and click [Select All].
Cyclic transmission restart
Link start allowed
Link start not allowed
Programming tool
Own station
1MP1
This station stopped
cyclic transmission by
specification from 1M
P1.
1N
S4
1N
S2
1N
S3
Cyclic transmission restart
Own station
Programming tool
1MP1
This station stopped
cyclic transmission by
specification from 1M
P1.
1N
S4
1N
S2
1N
S3
To Next Page
Loading...
